Post by Chavez on Oct 20, 2006 15:19:10 GMT -8
To add CTF mode to your map:
1. Look for the "mp" selection (in the view-->editor panel-->database) with the " + " in front of it. left click the +. Under the ctf section select the Flag_US.bes
2. Next, in the Mode properties section, above the drop down window, select the "..." In the Script window that opens select FLAG_US.c
3. Now parachute ("T" key on keyboard) the US flag to the terrain.
4. Now you can move the flag to your desired location. You may have to use the parachute key "T" again.
Now repeat the same steps above to script and place the flagpole for the VC side...
Your finished with the flags.
5. Next step is to make the Recovery Points for the US and VC players. Select View-->Editor Panel-->On. Now Select the "Database" tab in the Editor Panel. Scroll down until you see "Recovery Point". Double click that...
6. Now Select the "Properties" tab in the Editor Panel. In the drop down window select CTF_US.
7. Now move (press "M" on keyboard) this recovery point to the US CTF pole area and press the Parachute key ("T" on keyboard). Set the sink in: value to 0.0 . Now Duplicate that recoverypoint by pressing "D" key on your keyboard. Duplicate up to 32 times. Dont forget too many players causes much lag. I usually place 25 players per side on a large map.
8. Now do the same exact sequence for the VC side. Only difference is in the properties tab you will have to select CTF_VC in the drop down window. You will see the Recovery Point change a different color than the other ones.
Finished with adding CTF to your map
Rick (Chavez_US)
1. Look for the "mp" selection (in the view-->editor panel-->database) with the " + " in front of it. left click the +. Under the ctf section select the Flag_US.bes
2. Next, in the Mode properties section, above the drop down window, select the "..." In the Script window that opens select FLAG_US.c
3. Now parachute ("T" key on keyboard) the US flag to the terrain.
4. Now you can move the flag to your desired location. You may have to use the parachute key "T" again.
Now repeat the same steps above to script and place the flagpole for the VC side...
Your finished with the flags.
5. Next step is to make the Recovery Points for the US and VC players. Select View-->Editor Panel-->On. Now Select the "Database" tab in the Editor Panel. Scroll down until you see "Recovery Point". Double click that...
6. Now Select the "Properties" tab in the Editor Panel. In the drop down window select CTF_US.
7. Now move (press "M" on keyboard) this recovery point to the US CTF pole area and press the Parachute key ("T" on keyboard). Set the sink in: value to 0.0 . Now Duplicate that recoverypoint by pressing "D" key on your keyboard. Duplicate up to 32 times. Dont forget too many players causes much lag. I usually place 25 players per side on a large map.
8. Now do the same exact sequence for the VC side. Only difference is in the properties tab you will have to select CTF_VC in the drop down window. You will see the Recovery Point change a different color than the other ones.
Finished with adding CTF to your map
Rick (Chavez_US)